Pneumatic Leak Gauge Pressure Gas Tester
Pneumatic leak gauge Meeting standard: The waterproof tester is designed and manufactured according to the "IP code of enclosure protection grade" GB 4208-2008/IEC 60529:2001 issued by the national standardization administration of China, and it also refers to the waterproof test...
Pneumatic leak gauge
The waterproof tester is designed and manufactured according to the "IP code of enclosure protection grade" GB 4208-2008/IEC 60529:2001 issued by the national standardization administration of China, and it also refers to the waterproof test standard of part ix of GB 7000.1-2015/IEC 60598-1:2014 (dust proof, solid foreign body proof and waterproof).
Outdoor lighting industry\household appliances\auto parts\outdoor communication\
Mobile intelligent\mold manufacturing\medical equipment\third-party testing equipment
Function is introduced
1. The waterproof tester can be used in workshops, laboratories and other places to test the waterproof grade of [IPX8].
2. Waterproof tester - working principle:
Stage 1: place the sample on the tray in advance and pressurize the air inside the tank (the pressure can be set);
Stage 2:The second stage: after the pressure is completed, the sample goes into the water with the tray. After the tray reaches the bottom, the device begins to relieve pressure.
Stage 3: two situations may occur at this time: if the sample is defective, bubbles will continuously appear in the water, and the tester can observe the bubble position; If the sample is qualified, no bubbles will appear.
3.The test pressure and test time can be set through the touch screen. The pressure setting range: 0-0.5mpa; The time setting range is 0-9999 seconds.
4. Humanized design: 45 degree inclined plane mode, key operation; The lid is of moderate height for easy operation.
5. The equipment is equipped with a safety valve to prevent improper operation by operators. If the pressure is set too high, it will automatically relieve pressure if the rated pressure is exceeded.
6. Pressure control: panasonic pressure sensor is adopted to automatically control internal pressure.
7. Stainless steel pipe lock screws are used around the tank to enhance the safety of use.
Description of model: BND-jl-50a-10l
|Outside dimension||About 730* width 820* height 930mm|
|Internal dimension||Diameter 450* height 500mm|
|Tank wall thickness||25mm|
|Jar Material||polymethyl methacrylate|
|Flange Material||stainless steel|
|Sample tray size||400mm|
|Pallet height from bottom||145mm|
|pressure control mode||automatic adjustment|
|Sensor display accuracy||0.001Mpa|
|Test depth range||0 to 50 m|
|Presure adjusting range||0-0.5 Mpa|
|gas vent pressure of safety valve||0.55Mpa|
|Maximum limiting pressure||0.6Mpa|
|Test time setting range||0-999min|